Category: Heritage Guide

The Heritage Homes Guide

Tile laying method

Why Important 18th Century Tiles were made of local clay by hand, and therefore vary in colour and size. Clay plain tiles are flat, and are laid like slates. Changing the existing tiles with a different roofing material can lead to significant problems with the original roof structure. Failure of the roof leads to failures …

Continue reading

Suppliers and Installers

Note: This section is under continuous development. Although The Friends of Hamilton Square are unable to give endorsement to any particular Company or artisan, we welcome Companies or artisans who specialise in restoration work to contact us so they can be listed on this page. We are looking for local Companies and artisans who specialise …

Continue reading

Steps, Platts (Paving/Step) and Arches

Why Important Because the width of each step and platt (stone paving/step) stone is often as much as eight feet (2.5 metres), renewal can be expensive; minor damage is best left undisturbed, unless it affects the stability of railings or masonry. Worn treads and damaged nosings can be ignored unless they constitute a hazard. What …

Continue reading

RISING DAMP

Georgian buildings were not built with a damp-proof course (dpc), and most are subject to some rising damp, which is often recognisable by a continuous band of dampness and discolouration on the ground or basement floor, or by efflorescence on the plasterwork. Unless it is severe, rising damp is not a structural problem, though the damage to …

Continue reading

CONDENSATION

Condensation occurs when warm, moist air comes into contact with a cooler surface and is invariably accompanied by mould growth, which can form on any cold surface, including the contents of cupboards and wardrobes. Dampness from condensation usually affects the whole area of walls, ceiling and floor, unlike the patchiness of penetrating or rising damp, …

Continue reading

Slate Roofing

Introduction What to look for What to do if you find a problem Avoiding creating problems Historical background

Slate laying method

Why Important A well-slated roof can last up to 150 years. Regular maintenance is the key to keeping your roof performing well, avoiding unplanned and expensive emergency repairs. The more complex the roof, for example with dormers or hips, the greater the likelihood of problems. Originally, nailed slated roofs were fixed direct to the sarking …

Continue reading

Skirting Boards

Why Important The Skirting boards used in Georgian, Victorian and Edwardian properties are much taller (often 150mm tall) than 20th Century skirting boards (usually 30mm tall) and thus make a significant impression in a period home. What to look for Where there is any existing sample of original skirting in the room, then use that …

Continue reading

Scottish Slate (18th & 19th Century)

Why Important What to look for This West Highland slate is thick and has poor cleavage (splitting) which leads to a characteristic uneven surface texture. Unfortunately, West Highland Blue slates have not been quarried since the 1950’s so matching-in can be difficult. However, a good slater is likely to have a source of second-hand slates for patching. …

Continue reading

Rusting of Ironwork

Why Important Rusting metalwork loses its strength. The greater the rust, the weaker the metal. Painting adds additional protection to the metal from weathering and rusting. Wirral Council Planning Department recommends that all ironwork is painted black gloss and you will need Listed Building Consent and Planning Permission from them before you can change their …

Continue reading